25
.
Registration
Registering the Communicator
Once you have programmed the communicator, it must be registered. Registering the communicator
activates the account with AlarmNet and enables the security system's control panel to send reports.
Before the communicator is registered, the REG (green) LED will be on. You can monitor the
registration process by viewing the display LEDs. The REG (green) LED and STATUS (yellow) LED will
blink slowly in unison while registration is in progress.
LED
DESCRIPTION
REG
(green)
ON
Module is NOT registered with AlarmNet.
OFF
Module is registered with AlarmNet.
FAST BLINK
Download session with Compass in progress
SLOW BLINK In unison with STATUS (yellow) LED, registration in progress.
STATUS
(yellow)
PERIODIC
BLINK
Normal
FAST BLINK
Cannot deliver alarms
SLOW BLINK
•
Idle power abnormal
•
In unison with REG (green) LED, registration in progress
When the registration successfully completes, the communicator enters a normal operating mode;
the REG (green) LED turns off. If registration is not validated by AlarmNet within 90 seconds, the
communicator times out, and the REG (green) LED will be lit solid.
To register the communicator
, go to: www.alarmnet360.com
Please have the following information available:
•
Primary City ID (two-digit number).
•
Primary Central Station ID (two-digit hexadecimal number).
•
Primary Subscriber ID (four-digit number).
•
MAC ID and MAC CRC number (located on the box and inside the communicator).
1. Log in and choose “Programming” page.
2. Search for the account using the Account Information or MAC ID.
3. Under the “Actions” column, use the pulldown menu and select “Register” the account.
During the registration process, the
REG
(green) LED and
STATUS
(yellow) LED will blink slowly in
unison.
When registration has been completed successfully, the communicator enters normal operating
mode and the REG (green) LED turns off.
After the communicator is registered, you may log out of the AlarmNet 360 website.
Summary of Contents for LTEM-PA
Page 2: ......
Page 24: ...LTEM P Installation and Setup Guide 20 ...
