Honeywell Home LTEM-PA, Installation And Setup Manual

Page: 20 / 36

LTEM-P Installation and Setup Guide
16
2. Install the PROWIFIZW module by mating the module's connector to edge connector on the upper
left side of the communicator's PCB. Make sure the module is fully seated in the connector. Slip
the module board under the clip tab to lock it in place as shown below.
3. Affix the FCC/IC label provided with the PROWIFIZW to the communicator’s case back
4. After installation, power up the communicator then reconnect the battery.
Wi-Fi/Z-Wave Module Installation
3. Programming of the PROWIFIZW module, as well as the inclusion/exclusion of Z-Wave devices, is
done through the AlarmNet 360™ Programming Tool. On a laptop, PC or Smart Device, go to
www.alarmnet360.com.
NOTE
: When programming the communicator, make sure to program the communication path
to Wi-Fi & Cell.
4. When programming is complete, perform a Communications Test.
Wi-Fi
®
Setup
To set up a Wi-Fi connection to the router, you will need the AlarmNet 360 Mobile App installed on a
smartphone or tablet. The app is available for download from the App Store or Google Play.
You will also need the following information:
•
Communicator's MAC ID and CRC (both found on a label on the communicator).
MAC ID: CRC:
•
SSID and password for the router to which the communicator will be connected.
SSID: Password:
With the Wi-Fi module installed and the communicator powered up and battery connected, do the
following.
1. Connect your smart device to the same Wi-Fi network the communicator will use.
2. Turn on Bluetooth on your smart device.
Make sure the Bluetooth is not connected to another device.
3. Open the AlarmNet 360 Mobile App and log in.
3. Click the upper left menu icon (3 bars) and select "
Connect a Device to the Internet
" to display
the
Connect Device
page.
4. When prompted to
Activate Bluetooth on Device
, press and hold the communicator's Test switch
for at least 3 seconds to enter Bluetooth Pairing mode. The
REG
(green),
FAULT
(red), and
WIFI
(green) LEDs will blink in unison indicating the unit is in Pairing mode.
NOTE
: Pairing mode times out after 10 minutes of no screen activity.
5. Follow the instructions on the
Connect Device
page. Click "
Get Started
."
6. When prompted, select the communicator's MAC ID, then enter its CRC.
7. When prompted, enter the SSID and password for the Wi-Fi router.
8. Pairing mode ends after the last entry is made.