Owner´s Manual
59
After installing the wheel, apply the brake several
times and check for free wheel rotation when released.
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
Rear Wheel Removal
1. Raise the rear wheel off the ground by placing a
support block under the engine.
2. Remove the rear brake adjusting nut (1), disconnect
the brake rod (2) from the brake arm (3) by pushing
down on the rear brake pedal.
3. Disconnect the brake stopper arm (4) from the
brake panel by removing the cotter pin (5), stopper
arm nut (6), washer and rubber grommet.
4. Loosen the drive chain lock nuts (7) and drive chain
adjusting nuts (8).
5. Remove the rear axle nut (9) and pull out the rear axle
shaft (10), drive chain adjusters (11) and side collars.
Push the wheel forward and remove the drive chain
from the rear sprocket.
6. Pull out the wheel from the swingarm.
(9) Lug
(10) Slot
(11) Brake panel
(9)
(11)
(10)
(1) Rear brake adjusting
nut
(2) Brake rod
(3) Brake arm
(4) Brake stopper arm
(5) Cotter pin
(6) Stopper arm nut
(1)
(3)
(2)
(6)
(5)
(4)
(7) Drive chain lock nuts
(8) Drive chain
adjusting nuts
(9) Rear axle nut
(10) Rear axle shaft
(11) Drive chain adjusters
(8)
(10)
(7)
(9)
(11)
(11)
