4 of 24
AII 24378 (0303)
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
Illustration of an Installed XM Radio System
TOOL AND SUPPLIES REQUIRED
Phillips screwdriver
Stubby phillips screwdriver
Flat-tip screwdriver
Isopropyl alcohol
Shop towel
Tape measure
Utility knife
Hook tool
Ratchet wrench
8 mm and 10 mm Sockets
Felt-tip pen
Scissors
Push pin
Vinyl tape
Drill
3 mm and 10 mm Drill bits
Touch-up paint
Eye protection (face shield, safety goggles, etc.)
Masking tape
2N28160M
RECEIVER
UNIT
ANTENNA
DISPLAY MODULE
XM RADIO
HARNESS
FM MODULATOR
UNIT
DIN CABLE
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should not
be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2.
Disconnect the negative cable from the battery.
2N28010M
DISPLAY
MODULE
FM MODULATOR
UNIT
RECEIVER UNIT
FUSE BOX
6-PIN
CONNECTOR
VEHICLE
ANTENNA
CABLE
ANTENNA
XM RADIO
HARNESS
DIN CABLE
