© 2003 American Honda Motor Co., Inc - All Rights Reserved.
AII 24378 (0303)
15 of 24
39. Plug the DIN cable and the display module cable
into the FM modulator unit.
40. Attach bracket B with the FM modulator unit
against bracket A, and install one additional
6 x 12 mm washer-bolt. Tighten all three
6 x 12 mm washer-bolts securely.
41. Route the antenna harnesses from the FM
modulator unit rearward along the DIN cable
toward the inside of the front console.
42. Below the glove box opening, remove the upper
heater blower case mounting bolt.
43. Attach bracket C to the bottom of the FM
modulator unit with one 4 x 8 mm washer-screw,
and attach the other end of bracket C to the upper
heater blower using the bolt you removed in
step 42.
BRACKET A
6 x 12 mm
WASHER-BOLT
BRACKET B
DIN CABLE
DISPLAY
MODULE
CABLE
FM MODULATOR
UNIT
FM MODULATOR UNIT
ANTENNA HARNESSES
WIRE TIE
WITH CLIP
FM
MODULATOR
UNIT
BRACKET C
4 x 8 mm
WASHER SCREW
VEHICLE
BOLT
(Reuse.)
FM MODULATOR
UNIT HARNESS
3-PIN CONNECTOR
FM MODULATOR
UNIT ANTENNA
HARNESS
2524111M
BOLT
(Reuse.)
HEATER
BLOWER CASE
44. On the back of the FM modulator unit, attach one
wire tie with clip to the antenna harnesses,
and attach the wire tie with clip to the hole in
bracket C.
FM MODULATOR
UNIT ANTENNA
HARNESSES
FM MODULATOR
FM MODULATOR UNIT
HARNESS 3-PIN
CONNECTOR
