1. Set the heater temperature control dial to maximum heat.
2. When the radiator is cold to the touch, remove the radiator cap
and loosen the drain plug.
3. Remove the drain bolt from the
rear side of the cylinder block, and
drain the engine and heater.
4. Apply non-hardening sealant to
the drain bolt threads, then
reinstall the bolt and tighten it
securely.
5. Tighten the radiator drain plug
securely.
6. Mix the recommended antifreeze
with an equal amount of low-
mineral or distilled water and fill
the reservoir to maximum, as
illustrated.
7. Loosen the air bleed bolt in the
water outlet, then fill the radiator
to the filler neck with the coolant
mixture. Tighten the bleed bolt as
soon as coolant starts to run out in
a steady stream without bubbles.
8. With the radiator cap off, start the engine and let it run until
warmed up (fan goes on at least twice). Then, if necessary, add
more coolant mix to bring the level back up to the filler neck.
9. Put the radiator cap on tightly, then run the engine again and
check for leaks.
RADIATOR CAP
BLEED
BOLT
DRAIN PLUG
DRAIN BOLT
Fill to here
FILLER NECK
Fill to here.
Summary of Contents for 1992 Accord Wagon
Page 109: ...Maintenance Schedule cont d...
Page 151: ...Specifications cont d page 105...
