08B28-SMR-6001-96
12 / 32
iPod
®
is a trademark of Apple
Computer, Inc., registered in the U.S.
and other countries.
26. Prick the two marked positions with a pushpin.
Use an electric drill to drill holes with 3 mm
diameter at the two marked positions, and then
widen the holes with 5 mm drill bits.
•
Remove any burr.
6706300Y
PUSHPIN
ELECTRIC DRILL
(3 mm
5 mm drill bit)
GLOVE
BOX
Marks made in step 25.
Marks made
in step 25.
27. Secure the adapter unit with two 4 mm screws,
two screw caps, and two 4 mm flange nuts to
the 5 mm diameter holes of the glove box.
(Close the screw caps after securing the
adapter unit.)
6706310Y
ADAPTER
UNIT
GLOVE BOX
SCREW CAP
Close.
SCREW
CAPS (2)
FLANGE NUTS,
4 mm (2)
SCREWS,
4 mm (2)
Holes drilled in
step 26. (2)
28. Connect the iPod
®
harness connector to the
adapter unit.
29. Cut off the clip part of the two wire ties with clip.
Combine the two ties whose clips have been
cut off and use them to secure the iPod
®
har-
ness to the adapter unit.
6706320Y
DIAGONAL
CUTTER
WIRE TIE WITH CLIPS (2)
GLOVE BOX
WIRE TIE
WITH CLIP
CLIPS OF THE WIRE TIE
WITH CLIPS (2)
Cut off.
ADAPTER
UNIT
ADAPTER
UNIT
iPod
®
HARNESS
iPod
®
HARNESS
