Do not use forced water
and avoid wetting the mo-
tor or the electrical com-
ponents.
Do not use harsh products
for cleaning the chas sis.
Should you have any doubts or require clarification, do not hesitate
to contact your Sales outlet.
7. TROUBLESHOOTING
6
EN
PHENOMENON
CAUSE
ACTION
The Motor stops
during usage
Or
The Motor
does not engage
during correct
operation
The power cable plug
has fallen out of the
power socket
Connect the electrical
plug
and socket correctly
The power cable is cut
or broken
Repair or replace
the power cable
Motor safety device
works in below cases:
– Bade stops when
making contact
with obstacles
– The motor
has overheated
Wait for the safety
device to recover
(Aproximatly 1 hour)
– Remove any
obstacles around the
blade with the power
cable
unplugged
– Wait for the motor
to cool down
The Motor switch
is broken
Contact your
Honda dealer
The Motor is broken
The grass cannot
be mown or there
is not enough
power to mow
the grass
Or
Grass quality is
poor after cutting
Or
The Grass Bag is
not filling enough
The cutting height is
too low
Too much grass is
being cut at once
Adjust the cutting
height
Or
Reduce the cutting
width
The blade has worn,
broken or not been
installed correctly
Replace Blade
and or Grass bag
Remove grass
cuttings and clean the
housing, shoot and bag
Grass cuttings have
accumulated inside
the blade housing
or in the grass bag
Too much
vibration
The blade is broken
Replace with a new
Blade
The blade is bent
The Blade has not
been
assembled correctly
Reassemble the blade
correctly
6. ROUTINE MAINTENANCE
Regular, careful maintenance is essential for
keeping the safety level and original performance of the machine
unchanged in time. Store the lawnmower in a dry place.
1) Wear strong working gloves during any cleaning, maintenance
or adjustment operation on the machine.
2) Remove the grass debris after each cut and mud accumulat-
ed inside the chassis to avoid their drying and thus making the
next start-up difficult.
3) Always ensure that ventilation openings are kept clear of de-
bris.
Only blades with the following codes must be used on this machine:
HRE 330: VP5
HRE 370: VP6
Blades must always be marked «Honda».
Given the product evolution, the above mentioned blade may be re-
placed in time by others, with similar interchangeable and operating
safety characteristics.
Reassemble the blade
(2) with the code and
markings facing the ro-
tor, following the order
indicated in the illus-
tration, making sure the
spacers are replaced
correctly.
Tighten the screws (3)
with a torque wrench
set to 10-14 Nm.
CAUTION:
If you do not have the required skills of equipment, it is recommended
to ask your Honda dealer for adjustment.
A damaged or bent blade must always be
replaced; never try to repair it!
Breaking
A nicked part of an edge
A bended
Abrasion
WARNING!
IMPORTANTE
