5
HOW TO USE SONIDENT
1. Attach the brush head to the handle by positioning
the brush head at a 90-degree angle to the left of the
handle (See Figure A). Turn the brush head counter
clockwise one-quarter turn, so the bristles are facing
the same direction as the ON/OFF button, and the
brush head will snap into place (See Figure B).
2. Before brushing, wet the brush head to moisten,
then apply toothpaste.
3. To avoid splashing, guide the brush head to your
mouth before switching the SoniDent ON. Push the
ON/OFF button to activate the unit. The indicator
light will glow red when the power is on.
4. SoniDent has been designed with 3 different speed
levels to adjust to your own sensitivity level. Scroll
through the speeds (low, medium, high) by tapping
the arrow button.
5. Guide the brush head to your teeth, placing it at a
45-degree angle towards the gum line. Gently guide
the brush head from tooth to tooth, spending a few
seconds on the surface of each tooth.
6. Brush the gum lines as well as the teeth, starting
with the outside teeth and gums, followed by the
insides and finish with the chewing surfaces. Ensure
that you spend equal time in all 4 quadrants of your
mouth.
7. Do not press to hard or scrub with this unit. The
sonic waves penetrate difficult-to-clean areas,
removing plaque and bacteria.
8. The auto timer will automatically turn the unit off after
the 2-minute dentist recommended brushing time.
Note: To turn the unit off before the 2 minutes have
elapsed, simply press the OFF button.
9. Rinse mouth thoroughly with water.
10.Remove brush head and rinse under running water.
SoniDent, the easy-to-use sonic plaque
remover will enhance your oral hygiene. The
rapid movement of the SoniDent disrupts
plaque beyond the bristle tips for a more thor-
ough clean with less effort.
CHARGING INSTRUCTIONS
Follow this procedure before you use
SoniDent for the first time.
To reduce the risk of electric shock, this appli-
ance has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any
way.
1. Plug the charger base into a 120-volt outlet.
Place the SoniDent handle into the base
and allow it to charge for at least 16 hours
before using it for the first time.
2. The charger indicator light on the handle
will glow red when the toothbrush is
correctly placed in the charger base. This is
an indication that handle is charging. The
indicator will turn off when the toothbrush is
removed from the base.
3. The optimum voltage for charging is 120V.
4. To maintain the unit’s full performance, it
should always be replaced back on the
charging base after use.
Note: Charge for at least 16 hours before
using the unit for the first time.
INDICATOR
LIGHT
CHARGING BASE
ON/OFF
POWER
BUTTON
2 COLOR CODED
BRUSH HEADS
COVERED
BRUSH HEAD
STORAGE
DuPONT
®
SOFT
BRISTLES
4
Inside teeth
Outside teeth
Chewing surface
Figure A
Figure B
3 SPEED
SELECTOR
