Homa SaniQ Plus Series, Instructions Manual

Page: 25 / 34

25
4.4. Materials returned
Products that are returned to the factory must be clean and correctly packaged. "Clean" means that the product
has been cleaned of contaminations and that it has been contaminated in the event of use with mediums that a re
hazardous to health. The packaging must protect the product from damage. Please contact the manufacturer
before returning the product.
5. Installation and Initial Commissioning
5.1 General
In order to avoid damages to the lifting unit during installation and operation, the following points must be
observed:

The installation work must be performed by qualified personnel, in compliance with safety
regulations.

The lifting unit must be inspected for damage prior to installation.

Protect the pump from frost.

The power lines of the pump must be laid in such a way that a safe operation and eas y
assembly/disassembly is ensured.

A dry run is strictly prohibited.
5.2 Installation
It is up to the operator to prevent consequential damages, e.g. flooding of rooms during
disturbances of the pump, by means of appropriate measures (e.g. installation of an alarm system, a
reserve pump or similar).
The lifting unit must be installed in a manner that allows the lid to be opened. Ensure that there is
sufficient space between the side inlets and existing walls.
Please make sure to remove the transport safety (cardboard inside the container) prior to
commissioning.
According to the standard, sewage lifting units, which are located below the backflow level of the
drainage channel must be connected to the system via a suitable pipe loop. See installation example!
When operating with a shower, make sure that the shower drain is at least 270mm above the floor
of the lift system.
Installation