Installation
DKS 504 Vario | Version 1.03
9
6.3 Strokes and saw blade selection
Different types of saw blades can be used with the ma-
chine. The saw blade strength and amount of teeth/inch
(teeth division) depends on the radius to be cut.The nar-
rower the radius to be cut, the narrower the saw blade
must be and the amount of strokes must be also reduced
accordingly.
Reference values:
Teeth/inch
Approx. 10 t.p.i. wood from 6 mm to approx. 50 mm
Approx. 18 ZpZ fine sawing work, wood up to approx. 6
mm
Approx. 25 ZpZ plastic, GRP, non-ferrous metals, plexig-
lass
Selecting rotations:
The harder the material, the smaller the number of stro-
kes.
400–600 strokes/min. For narrow radii and thin material
from 0.25 to 0.3 mm
600–1200 strokes/min. For wood and plastic and extre-
mely thin cuts with material strength from 0.25 to 1.3 mm
1200–1600 strokes/min. For cutting hard and soft wood
from 0.5 to 5.0 mm in thickness. Also for plastic,paper,
aluminium, styrofoam, rubber, leather, cork.
6.4 Optional accessories
We recommend using only high-quality original Holzstar
accessories. Faultless operation and optimal work re-
sults can only be guaranteed with original accessories.
- Pin saw blades 135 x 3,0 x 0,25mm
Item number:
5911628
- Pin saw blades 135 x 6,0 x 0,4mm
Item number:
5911660
- Pin saw blades 135 x 6,0 x 0,4mm
Item number:
5911661
- Tool set 103-part in wooden case
Item number:
5912504
7
Installation
7.1 Requirements for the place of installation
Remove the jig saw from its packaging and remove any
protective film. Do not set up or operate the machine in a
damp or wet environment. The humidity should not ex
-
ceed 60% and the measured room temperature should
be between 0 ° C and 40 ° C.
The installation or working room must be dry and well
ventilated.
7.2 Setting up the JIG SAW
The Jig saw is already mostly delivered assembled. Only
a few parts have to be mounted after delivery.
To set up the saw is a workbench made of solid wood. A
noise reducing foam pad is not included with the saw.
Such a base is recommended in order to minimize vibra
-
tion and noise pollution.
The tools and hardware needed to mount on a work
-
bench were not supplied with the saw.
NOTE!
To reduce noise, a rubber interlayer can be placed
between the machine and the workbench. This effecti
-
vely prevents vibration and noise.
CAUTION!
Risk of injury due to a machine that is not stably er
-
ected!
Check the stability of the machine after placing it on
stable ground.
ATTENTION!
To ensure sufficient stability of the machine, it should
be screwed to the ground. There are 4 holes at the
bottom of the machine housing for this purpose.
DANGER!
Do not overtighten the screws securing the base
plate. The base plate must not be warped.
Wear protective gloves!
Wear protective clothing!
Wear safety shoes!
