Operation of the Jig Saw
DKS 504 Vario | Version 1.03
15
Step 11: After finishing sawing, switch off the device with
the red STOP button, switch off the suction and
disconnect the mains plug.
When pulling out the workpiece, the blade can be mis
-
diagnosed on average. This is usually caused by saw
-
dust which clogs the kerf. If that happens, do the follo
-
wing:
- Set the switch to OFF.
- Wait for the saw to stop and unplug the power cord.
- Remove the blade and the workpiece.
8.2 Carry out internal cuts
A feature of this scroll saw is the ability to make internal
cuts in a panel without damaging the exterior or perime
-
ter of the panel.
Step 1: Check that the machine is switched off and the
power plug is unplugged.
Step 2: Remove the saw blade.
Step 3: Drill a hole in the piece to be cut out inside the
workpiece.
Step 4: Place the workpiece with the hole over the ac
-
cess hole on the saw table.
Step 5: Guide the saw blade through the hole in the
workpiece, clamp into the holder and adjust the
blade tension.
Step 6: Carry out the cut.
Step 7: After completing the internal cuts, remove the
saw blade from the blade holders and remove
the workpiece from the table.
8.3 Cutting serveral workpieces
The scroll saw can be used to cut several identical sha
-
pes. Several workpieces can be stacked on top of each
other and must be secured together prior to cutting.
The stacked parts must be attached to each other so that
they can be handled as a single workpiece on the table.
8.4 Connecting a separate tool
Step 1: Turn off the power and disconnect the power plug
from the power outlet.
Step 2: Remove the cap of the separate tool connector on
the scroll saw.
Fig. 20: Remove the cover
Step 3: Connect the connection of the tool to the connec
-
tion of the scroll saw and tighten.
Fig. 21: Connect the worktool
NOTE!
The scroll saw has an attached work light which lights
up automatically as soon as the scroll saw is switched
on.
The light arm can be bent to bring the light in a
suitable position.
DANGER!
Before adjusting the device and before removing or
replacing the saw blade, the device must be switched
off and the mains plug must be disconnected!
DANGER!
To avoid injury, do not cut multiple workpieces that
are lying on top of each other if they are not
connected.
DANGER!
As soon as the tool is connected to the scroll saw and
the scroll saw is switched on, the tool also switches on
automatically. Therefore, make sure to hold the tool
firmly and securely when turning on the scroll saw.
