Holzmann TS 315F-1500, User Manual

Page: 38 / 59

MAINTENANCE AND CARE
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 38
Formatkreissäge / panel saw TS 315F-1500
5.3.2 Notes of using the circular saw

Set the guard of the saw blade.

Carry out the work evenly, without relapses and without take it back to the end of the cut-
ting.

Set the saw blade so high that the ring gear is really reliably covered by the protective cover
(distance between the protective cover and the workpiece - max. 5 mm

Perform the adjustment of the saw blade height and tilt only with the machine switched off.
5.3.3 Work only with good grounds tools

Use the push rod at the end of cutting when the distance between the circular saw blade and
the parallel ruler is less than 120 mm.

Make sure that the machine is working without vibrations.

Cracked and deformed saw blades can not be repaired. You need to be sorted out immediate-
ly as a committee and be replaced by ordinary.

For repair and maintenance of circular saw blades with soldered fins (eg soldering new cut-
ting blades) the construction of the circular saw blades (tooth shape, tooth width) must not
be changed. The circular saw blades with soldered fins can be grinding up to minimum di-
mensions of the plate of 1 mm

Then the circular saw blade must be removed from service.

Select the number of teeth of the saw blade so that at least 2-3 teeth working simultaneous-
ly). If only one tooth works, a poor working surface is, the danger of the vibrations and noise
pollution from increased setback increase.
6 MAINTENANCE AND CARE
A T T E N T I O N
Don’t clean or do maintenance on the machine while it is still connected to the pow-
er supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out
The machine is low maintenance and contains little parts that must undergo a maintenance oper-
ator.
Faults or defects that may affect the safety of the machine, must be rectified immediately.
Repair work may only be performed by qualified personnel!
The complete and utter cleaning ensures a long life for the machine and represents a safety re-
quirement.
After each shift the machine and all its parts must be thoroughly cleaned by the dust and swarf
sucked through the suction system and all other waste is disposed of by compressed air.
Check regularly that all warning and safety instructions on the machine and available in a perfect-
ly legible condition.
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.