Holzmann SB 3116RHN, User Manual

Page: 14 / 35

www.holzmann-maschinen.at
and engage the next Cap Spring notch.
Leave the screwdriver in place.
5. Tighten the (inner) Hex Nut just enough
to engage the notch.
If this Hex Nut is too tight, it will restrict
(up and down) Chuck-Spindle movement.
6. Pull the Feed Knob and check the spring
tension, making sure the up movement is
smooth and complete.
From one inch down, the Chuck should
return to its uppermost position. If more
tension is required, repeat steps.
7. Replace the (outer) Hex Nut (7) and
tighten on top of the (inner) Hex Nut. Do
not overtighten.
8. If the (up/down) movement is restric-
ted, slightly loosen the (inner) Hex Nut,
and retighten the (outer) Hex Nut.
1. Using compressed air, blow clean the
Table, Base, and Motor cooling vents of
dirt and materials.
2. Apply paste wax to the Table and Co-
lumn to enable movement and to help
keep surfaces clean.
3. All bearings are factory lubricated and
need no further attention.
4. Periodically, lubricate the Tube Column,
Table, and Spindle upper teeth with a light
oil.
5. Monthly, check the tightness of all
GENERAL MAINTENANCE
mounting screws and bolts in the Base,
Column, and Head assemblies.
6. Check belt for wear and replace if fray-
ed or damaged in any way.
7. Lubricate Spindle assembly with a light
oil, weekly.
8. Store in a clean and dry location.