Holzmann FS 200SF, Manual

Page: 16 / 44

www.holzmann-maschinen.at
5. MAINTENANCE
>> Visual check of machine, machine
parts, power cable, cutting tools
for any damage.
>> Check distance between tool and
table as well as fence. Check all
tightening levers and knobs being
tightened properly.
Clean the machine regularily after every
operation! Clean especially the table, the
fence faces and the mitre gauge.
Do not clean wood chips etc. by hand but
rather use a suitable brush tool and/or
pressure air.
Check regularily:
Bolts and connection looe
On/OFF Switch functioning?
safety components in proper condition?
tools sharp?
Lubrication:
Protect the table against rust with regu-
lar applications of light oil.
Add some grease onto the ways of the
sliding table.
Check every month the condition of the
V-belt. Check for cracks and glazing.
Avoid the V-belt and pulleys to become
dirty or greasy - this could cause belt
slips during operation.
You should replace at least once a year
the V-belt.
For V-Belt change consult the section of
V-belt tensioning in this manual.
After loosening the old belt, just remove
it and install the new one.
GENERAL MAINTENANCE
WARNING
!
Always switch off the motor and discon-
nect the plug from the power supply pri-
or to any maintenance, upkeep, checks
or cleaning.
CHECKS BEFORE OPERATION
ENGLISH