Holzmann FS 200SF, Manual

Page: 15 / 44

SPINDLE HEIGHT ADJUSTMENT
>> unplug the machine from the power
connection.
See Fig. H:
>> Loosen the spindle height lock (a).
>> Move the spindle up or down with
the spindle height handwheel (b)
until the desired position is
obtained.
To raise = turn counter-clockwise
to lower = turn clockwise
>> Secure the spindle height lock (a).
>> unplug the machine from the power
connection.
See Fig. I:
>> Loosen the Spindle bevel lock (a).
to loosen = turn counter-clockwise
to lock = turn clockwise
>> Make sure that the fence & table do
not touch the tool.
>> Move the spindle bevel with the
spindle tilting handwheel (b) until
it reaches the desired position.
>> Secure the spindle tilt lock (a).
See Fig. J:
>> With the main switch you start and
stop the machine.
(I) Green button for start
(O) red button for stop
>> The Forward/reverse switch
enables to operate the machine
in both directions.
Position L: The machine is running
at forward mode, the spindle is
running counter-clockwise.
Position R: The machine is running
at reverse mode, the spindle is
running clockwise.
The fence is a two-piece adjusting sys-
tem. Each fence is independently adjus-
table to compensate for different cutting
thicknesses and special milling applica-
tions.
SPINDLE TILT SETTING
MAIN CONTROLS
FENCE ADJUSTMENT
See Fig. K:
>> Loosen the fence lock handle (h)
>> Turn the spindle latch setting knob
(k)until the fence is set to the
desired position.
>> Tighten the fence lock handle (h).
See Fig. L:
>> Loosen the startype screw M8x25
(a) and (b)
>> Move the feed roller above the
workpiece.
>> Lock the startype screw M8x25(b),
make sure that the roller is as close
as possible to the workpiece.
>> Loosen the startype screw M8x25
(c) and (d).
>> Move the anti-kickback plate near
to the workpiece.
>> Lock the startype screw M8x25 (c),
so that the plate is 5-10mm above
>> Lock the startype screw M8x25 (d)
so that the plate is as close as
possible to the work piece that is
going to be processed.
>> Remove the Safeguard and feed
roller.
>> Adjust the spindle to the highest
position.
See Fig. M:
>> Insert the sanding drum(a) to
sanding sleeve (b).
>> Place the support disc (c) and
sanding drum assembly onto the
spindle.
>> Secure the lock flange (d) with
Allen bolt M12x25(e).
FEED ROLLER ADJUSTMENT
INSTALL SANDING ROLLER
ATTENTION
!
Sanding must be performed at 1800rpm
spindle speed!
ENGLISH