ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
35
TS315F1600
7.
Assembly hand wheel for height adjust-
ment of the saw blade / hand wheel saw
blade tilting
Place the hand wheel for adjusting the height
of the saw blade (1) on the shaft and tighten
it with a screw M6x16.
The hand wheel for adjusting the tilt of the
saw blade (2) is also mounted as described
above.
8.
Assembly swivel arm
Open the motor housing cover.
Mount the fixing bracket (4) on the outside of
the motor housing using 4 screws (1), 4
spring washers (2) and 4 washers (3).
At the inner side of the motor housing, screw
the 4 screws (1) to the connecting plate (5).
Tighten the screws (1) so that the swivel arm
remains in horizontal position.
NOTE:
You can check the horizontal position of
the swivel arm using a spirit level. A sloppily
mounted swivel arm leads to inaccurate cuts,
material distortion and defects!
Reinstall the motor cover on the machine.
9.
Assembly outrigger table
Insert the threaded rod (1) of the support rod
(2) into the borehole of the extension of the
swivel arm (4).
Insert the slot stones of the extension table
(3) into the T-slot (5) on the sliding table.
NOTE:
Adjust the height of the outrigger table
using the locknut system (6). The outrigger table
must be at the same height as the main table.
Check the adjustment using a spirit level.
As soon as you have adjusted this position, fix
the support rod with 2 locknuts (7).
Fix the outrigger table with the two handles
(8) in position on the sliding table.
