ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
36
TS315F1600
10.
Assembly cross-cut fence
Fit the cover (1) to the rear end of the cross-
cut fence.
Push the extended bracket (3) onto the main
bracket (2).
NOTE:
The cross-cut fence can be extended for
certain applications.
10.1.
Installation cross-cut fence
NOTE:
There are 2 positions possible for mount-
ing the cross-cut fence on the outrigger table:
(V) for front position and (H) for rear position.
Disassemble the star screw (1) and pivot
screw (2) located at the bottom of the cross-
cut fence.
Depending on the type of work fix the cross-
cut fence at the desired position on the out-
rigger table (front (V) or rear (H) position).
Position the star screw (2) in the guide (4) of
the outrigger table and fix the cross-cut fence.
By means of the scale (5) you can set the
cross-cut fence at any angle to the circular
saw blade.
After adjusting the cross-cut fence, retighten
the pivot screw (2) and the star nut (1).
11.
Assembly of components on the sliding
table
11.1.
Edging shoe
The edging shoe (1) can be moved along the T-
slot (3) on the sliding table.
Insert the slot stone into the T-slot (3) and fix
it in the desired position with the screw (2).
11.2.
Eccentric wood presser
The eccentric wood presser can be used horizon-
tally and vertically for any workpieces. It serves
for safe fixing of workpieces on the sliding table.
Screw the hexagon head screw (slot stone)
(6) with the washer ø10 (5) onto the eccentric
wood presser.
Insert the hexagon head screw (slot stone)
(7) into the T-slot on the sliding table.
12.
Assembly/exchange saw blade
Adjust the cutting height to the maximum
possible level.
Remove the saw blade guard (1) by slacken-
ing off the locking knob (2) and unhooking
from the riving knife.
