OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
50
KAM215EPSV
tablish the closing contact completely)
16.4.5
Other error-messages
Check the edge band saw unit in the respective error categories displayed.
Fault in the position switch for edge trimming
Faults in the magnetic switch for the front edge section
Faults in the magnetic switch for the rear edge section
Parameter settings on the display:
The following times and settings can be made
on the display, whereby parameters 3-10 do
not need to be changed.
1: Parameter preset to 40 (time setting for
feeding)
2: Parameter preset to 13 (time setting for
feeding delay time)
3: Set parameter to 6 ( setting for inverter )
4: Set parameter to 300 (feed setting)
5: Set parameter to 40 (setting time delay for
pre-milling cutter 1)
6:Set parameter to 150 ( setting working time
of pre-milling cutter 1)
7: Set parameter to 80
8: Set parameter to 50 ( Setting
9:Set parameter to 15 (blowing delay time =
setting delay time before starting blowing)
10:Set parameter to 35 (stop blowing delay
time = setting delay time for stop blowing af-
ter switch is deactivated)
