HOLZMANN MASCHINEN KAM 50M, User Manual

Page: 29 / 35

TROUBLE SHOOTING
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at Seite 29
MOBILES KANTENANLEIMGERÄT / EDGE BANDING MACHINE KAM 50M
15.2 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
N O T I C E
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.3 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
16 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble Possible cause Solution
Machine does not start
 Switch defective  Repair/change switch
 Power supply is off  Repair power supply
 Fuse is defective  Change fuse
Machine does not heat  Temperature controller defective  Repair/change controller
Edge band has insufficient
adhesive or is uneven
 Check adjustment  Adapt temperature
 Exert higher/less pressure

Attention to uniform and
slow drawing speed
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
N O T I C E
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.