MAINTENANCE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
76
ED1080ADIG
20.1.6
Replacing the V-belt
N O T I C E
Never replace V-belts individually but only as a complete set!
Open the screws on the cover (1) and remove it.
Loosen the adjusting nut (2) on the motor frame and
decrease the V-belt
Loosen the Allen screw (3) and remove the belt pulley.
Change the V-belts
Tighten the V-belts.
→
The tension is correct when a single V-belt can only be
pushed through a maximum of 5 mm with the thumb.
Tighten the adjusting nuts again.
Remount the cover (pay attention to the position
switch!)
20.1.7
Replacing jaws
To replace the jaws, you must open the lathe chuck with the chuck key. In the fully open
position, the jaws can then be removed one by one.
The following must be observed when
inserting the jaws:
The threaded segments (2) of the jaws
are graduated as shown in the figure.
In addition, they are numbered (1) from 1
to 3 to indicate the actual pitch in the
lathe chuck.
Therefore, make sure to mount the jaws in the correct order:
1.
Arrange the jaws as shown in the figure above and insert them clockwise into the slots of
the lathe chuck in this order.
2.
Hold the jaws and clamp them with the chuck key.
3.
Close the chuck completely and check that the jaws meet in the middle.
If a jaw does not fit properly, open the lathe chuck, press firmly on the jaw and turn the chuck
key until the jaw is in the correct position. Check again that the jaws meet in the middle.
20.1.8
Adjusting the overload clutch on the feed spindle
N O T I C E
Never fully tighten the overload clutch set screw beyond the normal setting described
in this procedure. Severe gear damage could result.
Summary of Contents for ED1080ADIG
