HOLZMANN MASCHINEN ED1080ADIG, User Manual

Page: 60 / 121

OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 60
ED1080ADIG
The retraction must be carried out at the lowest spindle speed. Let the machine run at this speed
for about 1 hour. Pay attention to any abnormalities and/or irregularities, such as unusual noises,
unbalance, etc. If everything is OK, gradually increase the speed. The highest speeds may only
be reached after 10 hours of operation.
If unusual noises or vibrations occur during the test run, stop the machine immediately and read
the Troubleshooting section. If you cannot find a remedy, contact your specialty retailer or
customer service.
18.3 Operating the machine
18.3.1 Control Icons
Main switch
I: ON
0: OFF Coolant
Green: On
Red : Off
Half nut opened Half nut closed
Metric thread Imperial thread
Right-hand thread and longitudinal feed to the
headstock side (left illustration)
Left-hand thread and longitudinal feed to
tailstock side (right picture)
H
Fast mode (High)
L
Slow mode (Low)
Neutral Clutch
Longitudinal feed
engaged (top)
Both feeds
disengaged (middle)
Cross feed engaged
(bottom)
Oil inlet (hole)
Do not change speed
or direction of
rotation during
operation!
Electric voltage
Intermittent push
button
Power indicator light Emergency-Stop