4. Press the Start/Stop button on the
remote control to begin the treatment.
Note:
The LED on the WiTouch device
will flash rapidly during treatment.
5. Press the (+/-) buttons to increase or
decrease the intensity of the stimulation
until it is at a comfortable level.
6. Press the Start/Stop button on the
remote control to stop the treatment at
any time. Treatment will automatically stop
after 30 minutes.
Note:
If a treatment is
stopped and restarted the treatment will
restart at the first stage.
Removing the WiTouch
Important! Do not remove the device until the treatment has stopped.
1. After treatment, or when you want to remove the device, grasp the edge of the device
and gel pad to ensure the gel pad does not stay on the skin. Slowly peel the device away
from the skin.
2. Align, and place the green protective liners back on the gel pads. Ensure the pads are
completely covered.
Battery Replacement
When battery replacement is needed the LED will flash as follows:
To replace the WiTouch Device Batteries:
1. Using the included #0 Phillips head
screwdriver remove the cover.
2. Remove the old batteries, and place the
new batteries in the correct polarity.
3. Replace the battery compartment cover.
To replace the remote control battery:
1. Place the provided screwdriver, coin or
flat tool in the groove on the side of the
remote control. Turn the coin and lift the
cover off.
2. Slide the old battery out, and slide a new
CR2032 battery into the slot.
Note:
The
(+) is facing upward.
3. Align the cover with the remote control
base. Holding the handle portion of the
remote control, snap the cover down
into place.
Note:
Consult your local authorities for proper
battery disposal.
Item
Description
Battery
WiTouch
device
LED flashes yellow every two (2) seconds when
the unit is On
(2) AAA alkaline
batteries
LED flashes yellow rapidly during treatment
Remote Control LED will flash yellow once when the Start/Stop
button is pressed.
(1) CR2032 lithium
battery
6
5
4
