B U L L E T I N
G L V - 4 0 S 1 # 1 1 9 6 G E A R L E S S T R A C T I O N M A C H I N E
Page 7-9
Rev. A - 04/01/2022
7. Adjust the guide screw sleeve of guide screw 2 and the mounting bolt of insulation bolt
1, so that the air gap between the armature of armature 5 and the armature of armature
iron 4 is between 0.012” (0.30 mm) to 0.022” (0.55 mm), the gap between the brake belt
a
nd the brake wheel is 0.004” (0.10 mm) to 0.006” (0.15 mm), and the distance between
the guide screw sleeve of guide screw 2 and the iron surface of armature iron 4 is about
0.197” (5 mm). no less than 0.118” (3 mm) under any conditions, as shown in Figure 33.
Brake Adjustment
After installation of the brake, please refer to Section 0 to confirm brake is centered and air gap
has been restored to factory specifications
WARNING:
Brakes must be burnished to achieve full stopping torque!
Figure 33
1) INSTALLATION BOLT
2) GUIDE SCREW
3) BRAKING PAD
4) ARMATURE IRON
5) ARMATURE
