Holland FW35TT/XA-351-TT Series, Rebuild/Repair Manual

Page: 12 / 20

12 XL-FW20130RM-en-US Rev C · 2022-01-03 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Figure 14
Figure 15
Rebuild Procedures
7. The cam plate has a link pre-installed beneath it. Align
the hole in the link and the cam plate track over the
threaded hole in the yoke
(Figure 14) .
8. Place a 5/8" I.D. roller into the hole in the link. Then
place the 5/8" I.D. x 1-3/4" O.D. washer over the cam
plate and above the roller with the rounded side of the
washer facing the cam plate
(Figure 14) .
9. Check the alignment of the threaded hole in the yoke
with the recessed hole in the yoke shaft. (Refer back to
Figure 8 .)
10. Install the M16 x 2 x 50 mm hex head cap screw through
the washer, cam plate track, cam plate link, and roller,
into the threaded hole in the yoke
(Figure 14)
. Hand
tighten until the hex head cap screw enters the recessed
hole in the yoke shaft.
11. Tighten the hex head cap screw further until it bottoms
out in the yoke shaft. Ensure the gap between the washer
and the cam plate is no more than .120" (3.04 mm)
and no less than .06" (1.52 mm). Then check for free
movement of the cam plate
(Figure 15) .
.06" (1.52 mm) MIN. GAP
.120" (3.04 mm) MAX. GAP
YOKE
YOKE
SHAFT
BOLT MUST
BOTTOM OUT IN
YOKE SHAFT
CAM PLATE
LINK AND
ROLLER
CAM PLATE TRACK
THREADED HOLE
IN YOKE MUST BE
ALIGNED WITH HOLE
IN YOKE SHAFT
CAM PLATE
CAM PLATE TRACK
(CAM PLATE SHOWN
MOVED FOR CLARITY
PURPOSES)
M16 x 2 x 50 mm
HEX HEAD CAP SCREW
5/8" I.D. x 1-3/4" O.D.
WASHER
LINK HOLE ALIGNED
WITH CAM TRACK
AND YOKE HOLE
5/8" I.D. ROLLER