Holiday Admiral 2016, Manual

Page: 95 / 162

93
e
qu
Ipment - 5
2016 Admiral
CAUTION:
Clean the floor before retracting the
slide room. Dirt and grit trapped
under the slide room can scratch and
damage the floor. Never move the
motorhome with the slideout room
extended.
CAUTION:
Do not use petroleum based products
on the slide seal. Petroleum based
products can damage the paint and
will cause premature aging of the
rubber seal.
WARNING:
The outside area must be clear of
obstruction that can restrict slide
room operation. Ensure there are five
or more feet of clear space outside the
slide room prior to extending the room
or damage to the slide, motorhome
or property can occur. Ensure there
is sufficient clearance inside the
motorhome prior to retracting. Clear
the area of people and pets.
CAUTION:
Continuous operation of the slideout
room can drain the batteries and
overheat the motor.
CAUTION:
If a problem with the slideout occurs,
contact a qualified technician.
Troubleshooting
If the slide room does not operate, a safety
feature may be engaged to prevent room
operation.
If slide room does not respond from
switch, check the following safety
requirements:
Ignition key is off.
z
Park brake is applied.
z
House battery disconnect switch is on.
z
House batteries are charged.
z
The motorhome is level.
z
Manual Override
Living Room/Galley Slideout:
While it is recommended to diagnose and
repair the problem so the in-wall slideout
system operates as intended, conditions
may require the slideout room be retracted
manually. The in-wall system uses a 12 Volt
DC motor located at the top of each slideout
assembly. Gears mesh with the upper and
lower racks that are connected by a drive shaft.
A control module monitors the revolution
of each motor to ensure synchronous room
movement. Unplugging each motor from the
control module will allow the motors to rotate
providing there is not mechanical interference
or damage to the gears and racks.
NOTE:
Several people may be required to
push the slideout room to the retracted
position.
Manually Retract the Slideout Room:
1. Access either the inside or outside
(whichever is easier) the vertical
channel assembly by removing trim
and flange pieces around the slideout
room.
2. If applicable, remove the top screw
from the bulb seal at the top of the
vertical.
3. Pull down on bulb seal and remove
the motor cover.
4. Use a pick tool or equivalent to
remove the retaining spring from the
motor spring clip. If not equipped
with a retaining spring, loosen the
motor retaining screw.
5. Unplug the motor from the harness
and remove the motor by lifting it up
and out.
6. Repeat steps 1-4 for the other side.
031277g
Motor location
Bulb Seal Screw
Rack
031277f
Channel
flange