148
house ele
C
tr
IC
al - 8
2016 Admiral
Calculating the exact run time is not precise
due to all the variables and equations involved;
however, an approximate time figure can be
obtained. Proper battery maintenance and
charge cycles affect battery performance.
Observe the battery condition with hydrometer
and voltage readings. Use only distilled water
when filling batteries. To achieve the highest
quality of battery performance and longevity
maintain the batteries in their proper operating
range.
How long will the batteries last?
Conduct this eight-hour test to determine
how long your particular battery bank will
operate before dropping below 50% state of
charge.
1. Before beginning the test, be sure
the batteries are at 100% charge by
verifying with a hydrometer or an
accurate voltmeter.
2. Turn the interior house power on.
Turn on several lights.
3. After the eight-hour period, turn off
the lights, refrigerator and interior
house power. Allow the battery
electrolyte to stabilize for at least one
to three hours.
Test the batteries again with a hydrometer
or voltmeter. Are the batteries above or below
50% State of Charge? This test will give an
idea of how long your particular battery bank
will actually last.
LIgHTs
Depending on floor plan, actual styles may
differ.
To Replace a Bulb:
1. Carefully squeeze the lens cover then
gently pull the cover out. The cover
has tabs that lock the cover in place.
2. Using a clean cloth or piece of tissue
carefully grasp the bulb and rotate to
the unlock position.
3. Remove bulb from the socket.
4. The bulb replacement is 1141 12V
21CP.
5. Using a clean cloth or piece of tissue
grasp the new bulb and align the
prongs on the bulb with the slot on
light socket.
6. Push bulb in and rotate to lock
position.
7. Gently squeeze lens cover and insert
tabs on cover into fixture.
INFORMATION:
Confirm replacement bulb number
before ordering or obtaining a
replacement.
CAUTION:
Allow bulb to cool down before
replacing.
Interior Halogen
To Remove:
1. Grasp light fixture and pull down
slightly then tilt fixture to one side.
This will allow one spring clip to
come out.
CAUTION:
Push spring clip inward with a finger
as clip is being eased out. Hold clip to
prevent clip from pinching fingers.
2. Tilt fixture to other side and ease the
other spring clip out.
3. Unscrew the light lens
counterclockwise and remove.
080475c
060200d
Summary of Contents for Admiral 2016
