Equipment
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
2 0 0 2 N E P T U N E
5 • 161
To Retract the Main Slide-out Room:
• Check for sufficient clearance inside the motorhome before
retracting the slide-out room.
• Clean the floor, if applicable, to ensure there is no dirt or grit that
could result in floor damage during operation.
• Move the driver's seat forward.
• Inspect the exterior to ensure there are no sags in the awning mate-
rial.
• Remove any debris from the top of the slide-out room.
• Prior to retracting the slide-out room, start the motorhome. Allow
the air bags to fully inflate to normal travel height.
• Retract the leveling jacks prior to operating the slide-out.
• Turn the ignition switch
OFF
. The slide-out room will not operate
with the engine running.
• The house batteries should be fully charged.
• The park brake must be applied.
• Ensure all people, pets and objects are clear of the slide-out room
path.
• Press and hold the switch in the
IN
position. The slide-out room
will move slowly in. To stop the slide-out room, release the switch.
To continue the room movement, push and hold the switch in.
• Release the switch.
• Rain water can pool on the slide-out awning. Added weight will
cause the awning to sag. Upon retracting the room, the material
can catch between the top of the slide room and the opening in the
the motorhome. It will be necessary to retract the room in small
increments, allowing the water time to run off.
• If applicable, place locking bar mechanisms between the wall and
top edge of the slide-out room to lock room in place.
NOTE: Be sure you have sufficient clearance on the inside
of the motorhome (driver's seat, etc.) before you retract the
slide-out room. Ensure the floor is clean before you retract
the slide-out room. Trapped dirt or grit under the slide-out
room can scratch the floor surface. Never move the
motorhome with the slide-out room extended.
The slide-out system can be retracted in the event of a power loss.
If the room does not move when the switch is pressed:
• Check if the battery is fully charged and connected.
• Make sure the locking bar mechanisms are removed.
After the previous items have been checked and the room still does not move
when the slide-out switch is pressed, follow these simple steps to manually over-
ride the slide-out room:
Retracting Main
Room(s)
Manual Override
Main Slide-out
Summary of Contents for 2002 NEPTUNE
