Hokkaido HCKI 275 XS, User Manual

Page: 22 / 44

-22-
TIMER FUNCTION
TIMER OFF (Programmed Stop)
NOTES:
Programmed Stop - TIMER OFF
Example of TIMER OFF setting
To stop the air conditioner in 10.00 hours:
Press the TIMER OFF button: the last setting of stopping operation
time and the signal “h” will show on the display area.
Press the TIMER OFF button to display “10h” on the TIMER OFF
display of the remote controller.
Wait for 0.5 seconds; the TIMER OFF indicator stops flashing
and this function is activated. The digital display area will show the
temperature again. 1.
2.
3.
ADJUST
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
MO
DIRECTION/
SWING
CLEAN
AIR
DE
FAN SPEED
TIMER ON
SLEEP
ON/OFF
TIMER OFF
AUTO
CLEAN
FOLLOW
ME
RESET LOCK
SET TEMPERATURE
LED
DISPLAY
TURBO
(°C)
1
TIMER ON
h
TIMER OFF
Stop
10 hours later
On
Impostazione
h
~
~
~
~
TIMER OFF function allows you to program the automatic
stop of the air conditioner according to your needs.
In this way, the air conditioner will stop operating at your
desired time.
1.
2.
Press TIMER OFF button: remote controller will
display “TIMER OFF” indication, the signal “h” and
the digits for programming the setting. The remote
controller is ready to receive the setting for TIMER
OFF.
Press again TIMER OFF button for several times, till
reaching your desired time for the air conditioner’s
automatic stop. At each press of the button, time
increases by 30-minutes’ steps till 10 hours, and
by 60-minutes‘ steps from 10 to 24 hours.
3. After 0.5 seconds since the time for programmed
stop was set, the remote controller will send settings
to the Indoor Unit. After 2 seconds, the signal “h”
will go out and remote control will display set
temperature again.
When “TIMER” function is selected, the remote controller automatically sends signals for programmed start/stop to the
Indoor Unit. If you would like to be sure that these signals are received by Indoor Unit, it is necessary to address the
remote controller towards the Indoor Unit’s signal receiver, and check that no obstacles could affect the impulses’
transmission.
CAUTION !
Time increases are 30-minutes’ steps till 10 subsequent hours, and 60-minutes’ steps from 10 to 24 hours.
The remote controller’s Timer is not a clock, so it is necessary to set the time period - not the exact time - for
programmed stop.
Unlike operation modes, TIMER settings are not kept in memory by the microcomputer, therefore if a power
failure occurs, TIMER settings will be cancelled and need to be set again.
Before selecting TIMER settings, it is possible to choose your desired operation mode.
TIMER max. range is 24 hours, i.e. it is not possible to operate weekly settings.
To modify TIMER settings, press again TIMER OFF button and repeat the above procedure for TIMER OFF setting.
1.
2.
3.
4.
5.