Hog Technologies Stripe Hog SH8000, Operation Manual

Page: 62 / 192

62 62
Stripe Hog Systems
Mode Switch (Automatic Transmission Only)
Activates 4/4 Lockup Mode in the transmission
when the PTO switch is activated. 4/4 Lockup is a
pre-programed Operate Mode for the transmission
that selects the gear that provides a 1 to 1 engine/
transmission gear ratio at the transmission output
shaft and locks the torque converter to eliminate
slip. This setting provides the proper RPM to en-
gine powered waterblasting components activated
by the PTO and 40K Clutch while in Operate Mode.
NOTICE:
TRuCKS WITH MANuAL TRANSMISSIONS WILL NOT BE
EquIPPED WITH A MODE SWITCH. THE OPERATOR MuST
MANuALLY SHIFT THE TRANSMISSION TO THE PROPER
GEAR FOR OPERATE MODE. A PLACARD ON THE BACK
OF THE SuN vISOR PROvIDES THE STARTuP PROCEDuRE
AND INSTRuCTIONS FOR PLACING THE TRANSMISSION IN
THE PROPER GEAR FOR OPERATE MODE.
Charge Pump Switch
Activates the solenoid valve in the hydraulic mani-
fold that supplies pressurized hydraulic fluid to
power the charge water pump.
40K Clutch
Activates the clutch in the OMSI gearbox that
powers the drive belts for the ultra high pressure
pump and the vacuum blower. (Only engage the
40K clutch with engine at idle speed)
Camera
Activates the video cameras that monitor selected
operations of the waterblasting system.
Work Light
Activates the lights that illuminate the blasting
area and specific waterblasting system compo -
nents.
Strobe Light
Activates the safety strobe lights during opera-
tions.
Debris Tank Drain
Activates pneumatic powered drain valves located
in the bottom of the debris tank that drain the
waste water from the tank.
Auxiliary Switches
Reserved for additional equipment installed by
Hog Technologies or the truck owner.
Drive Mode/Operate Mode Lights
Colored LED lights that indicate the status of the
operation mode selected.
• Green light illuminated indicates the truck
has been successfully shifted into Drive
Mode. All waterblasting functions are can-
celled and the truck is ready for highway
operation.
• Red light illuminated indicates the truck
has been successfully shifted into Oper-
ate Mode. The truck highway drive train is
disabled, the hydrostatic drive is enabled
and all water blasting functions are avail-
able for activation.
Split Drive Oil Lights
Red LED warning lights that indicate specific prob -
lems in the OMNI gear case.
• Front Temp light illuminated indicates the
fluid that cools and lubricates the 40K
Clutch has exceeded safe operating tem-
perature.
• Left Level light illuminated indicates low
fluid level in the forward section of the gear
case and the 40K clutch.
• Rear Temp light illuminated indicates the
fluid temperature in the hydrostatic and
hydraulic pump section of the gear case
has exceeded safe operating temperature.
• Right Level light illuminated indicates low
fluid level in the rear section of the gear
case.
Hour Meter
Activated by the PTO switch. Records the total
operating time of the waterblasting equipment.
Drive Mode Lights