18
4-6
4-5
4 5 6
10
7 8 9
1 2 3
1 2 3
4 5 6 7 8
Layout
HWM mode has been previously carried out.
The SWM indicator lights up if the operator has
activated this program.
4, 8 Weight Position indicator
Fit a clip or stick-on weight in the rim position
indicated when this plane’s WAP indicator lights up.
5, 6, 7 Weight Position indicator
Fit a stick-on weight at the indicated rim position
when this plane’s WAP indicator lights up.
4.1.1
System signals
Possible beeps:
High:
the unit returns a short high beep after activating
a key (
F
4.2).
Low:
the unit returns a low beep if an error is detected,
usually together with a system message.
Error messages can also be indicated
by means of acoustic signals.
The service technician can locate and eliminate the
corresponding error by means of the number of tones,
their frequency and duration (long/short) and the length
of the pauses.
4.2
The input panel
Refer to Figure 4-6.
1. Diameter key with indicator
Press to select “rim diameter” mode. The diameter
indicator will light up, the unit will beep.
The current value will be shown on the display and
can be edited.
2. Width key with indicator
Press to select “rim width” mode. The width
indicator will light up, the unit will beep.
The current value will be shown on the display and
can be edited.
3. Offset key with indicator
Press to select “offset” mode. The offset indicator will
light up, the unit will beep.
Pressing the offset key in HWM enables the
operator to access the plane reference points again.
..
..
..
.
..
.
