122
iii-1
iii-2
iii-3
iii-3a
1
2
3
4
5
6
7
8
6
Installation
iii Installation procedure
Unit:
Refer to the drawing in i section for correct
wheel balancer positioning. If the wheel balancer
needs securing, we recommend fi xing elements
with a diameter of 8 mm, quality 8.8 or higher.
Supports for Accessories:
•
Unpack the 4 threaded accessory support pins and
the support plates.
•
Refer to
Figure iii-1
. Fit the 4 threaded accessory
support studs and the plates.
Threaded shaft:
(except for “P” machines)
•
Clean the threaded shaft and the hole in the main
shaft.
•
Refer to
Figure iii-2
. Position the threaded shaft.
•
Use a pin for screwing.
Clamping devices:
•
Put the clamping devices on the accessory support
pins and in the appropriate housings.
Wheel guard:
•
Refer to
Figure iii-3
.
The wheel guard infl uences the following operating
modes:
—
The measuring run is started by closing the wheel guard.
—
The wheel is braked by lifting the wheel guard during a
measuring run (code C5).
Fig. iii-3
—
Slide the wheel guard (
1
) on the support shaft (
2
) and
rotate the tube of the wheel guard until the wheel guard
fastening holes match with the support shaft holes.
—
Insert the M10 fastening screw (
3
) from with washers (
4
)
from below and tighten fully home the hexagon nut (
5
)
and washers.
Figure iii-3a
(only for machines with Sonar)
—
Connect the plug of the cable (
6
) with the connector of
the machine (
7
) which is projecting out of the opening of
the machine cabinet.
—
Place the plug cable loosely inside the machine through
the hole in the machine cabinet.
Warning
:
Since the cable is moved during the wheel guard
opening and closing, it must be routed through
retainer (
8, Fig. iii-3a
) under the guard support.
..
..
..
.
..
.
