52
5-16
Operation
•
Position the valve exactly perpendicular to and
above the main shaft.
•
Press the
PRO-MATCH
key (2) to acquire the valve
position.
OP.4 appears.
•
Press the
START
key.
The measuring run is carried out. After the measuring
run two readings are possible:
OP.5 - H1
Further optimisation is not recommended, but possible.
OP.5 – Reference mark
Continue with the OP program.
Reading OP.5 - H1
If OP.5 - H1 appears, further optimisation is not
recommended, since the measurement values which
activated the optimisation recommendation are below
the limit value. However, it is possible to continue
optimisation for the most silent possible wheel running,
reducing imbalances below the limit value (critical
vehicle).
To continue optimisation
•
To continue with the OP program proceed as
specifi ed for OP.5 – Reference mark (see next
page).
To abort optimisation
•
Press the
STOP
key to return to the balancing
program and balance the wheel according to the
readings.
Reading OP.5 - Reference mark
•
After the measuring run readjust the wheel following
the direction indicator and make a chalk mark on
the right side of the tyre exactly perpendicular to
and above the main shaft.
•
Readjust the tyre on the rim so that the reference
mark made is aligned with the valve (use tyre
changer).
•
Clamp the wheel on the balancer and readjust it until
the valve is exactly perpendicular to and above the
main shaft.
•
Press the
PRO-MATCH
key (2) to acquire the valve
position.
The OP.6 reading appears.
•
Press the
START
key.
After the measuring run four readings are possible:
=== - OP.7
Proceed with the OP program. It is recommended that
the tyre be turned over on the rim.
OP.7 - ===
Proceed with the OP program. It is recommended that
the tyre be turned over on the rim.
H0
Optimum condition has been achieved and cannot be
improved.
..
..
..
.
.
3
4
1 2
Summary of Contents for geodyna 7100
Page 94: ...94 Blank Page ...
