Instruction manual
No. 2117-2e
2.98
1.6. Impulse
generator
The impulse transmitter normally will be activated by the inner side of the left front
wheel. When using the MALCON 2 system no.: 97 02 370 with this impulse
generator or when using the control unit 97 01 930 at the bottom-wheel impulse
transmitter of the MALCON unit, the other rotating direction should be noted.
Change the connexions 1 and 3 in the impluse transmitter.
1.7.
Adjusting the impulse generator
Set the cycle
at, for example, 2000 (20 m) and length of the line
at a very low factor, for example 10 cm.
Switch on the control unit.
Set the "Semi-Man-Auto" switch to "Auto". Drive off and set "Start-Stop" switch to
"Start".
Drive slowly through a distance of two to three cycles, so that two or three short
lines are marked.
Measure the cycle (beginning of line to beginning of line or end of line to end of
line), more preferable, several cycles.
If the measured cycle is longer than the set length, then the impulse spacing is
greater than 1 cm, i.e. the impulse generator rotates too slowly. The friction disk
on the wheel must be pushed towards the outer edge.
If the measured cycle is shorter, the friction disk on the wheel must be pushed
towards the inner edge.
