Passenger Tire Changers Service Manual 07-13 Rev.B
83
TO ADJUST THE VERTICAL TOOL CLEARANCE:
Block a 17” rim diameter rim in good condition to the centre post.
Unlock the front screws and tighten all way down and then turn
them backward of two turns each one.
Lock the counter nuts.
Place the tool on the rim, as normal operation, and then lock it.
Make sure that the clearance between plastic protection and rim is
2mm.
If the clearance is higher, release the arm, unlock the screws and
tighten them accordingly. Then lock the screws again.
If the clearance is lower, release the arm, unlock the screws and
loosen them accordingly. Then lock the screws again.
Check if the machine works fine
TO ADJUST THE VERTICAL ROD BLOCKING PLATE:
Press the yellow button valve to lower completely the vertical tool
rod.
Tighten as much as possible the vertical blocking cylinder
adjustment screw in order to block the rod.
Pull the yellow button valve all towards the operator in order to lift
the vertical tool rod.
Turn counter clockwise the vertical blocking cylinder adjustment
screw until the vertical rod will move upward.
Then perform some rod lowering and raising operations to make
sure that the rod is moving smoothly.
Block the counter nut.
TO ADJUST THE VERTICAL ROD BLOCKING PLATE SPRINGS:
