1
5
(default 100)
shall vary with PIT-RAT value. While the collective pitch stick moves from collective
pitch neutral point to highest end, adjust value and keep swashplate aileron side at
horizontal level all the time.
2. ELE-HEND-----Settings for High Point Travel of Elevator Servo
Item
Content
0
～＋
200
(default 100)
The elevator high-end travel which pushes forward collective pitch stick to bottom
shall vary with PIT-RAT value. While the pitch stick moves from collective pitch
neutral point to highest end, adjust value and keep swashplate elevator side at
horizontal level all the time.
3. PIT-HEND-----Settings for High Point Travel of Pitch Servo
Item
Content
0
～＋
200
(default 100)
The pitch high-end travel which pushes forward collective pitch stick to bottom shall
vary with PIT-RAT value. While the collective pitch stick moves from collective
pitch neutral point to highest end, adjust value and keep swashplate pitch side at
horizontal level all the time.
SWPL SERVOS TRIM Submenu Configuration Steps:
1
、
、
、
、
AIL-TRIM-----Aileron Servo Neutral Point Fine Tuning
Note: Aileron SUB TRIM value should be set to zero in transmitter.
Item
Content
－100 ~ +100
(Default is 0)
Adjust the position of aileron at 0 collective pitch as well as the value until the
swashplate is in horizontal.
2. ELE-TRIM----- Elevator Servo Neutral Point Fine Tuning
Note: Elevator SUB TRIM value should be set to zero in transmitter.
Item
Content
－
100 ~ +100
(Default 0)
Adjust the position of elevator at 0 collective pitch as well as the value until the
swashplate is in horizontal.
3333、
、
、
、PIT
PIT
PIT
PIT----TRIM
TRIM
TRIM
TRIM-----
-----
-----
-----
Pitch Servo Neutral Point Fine Tuning
Note: Pitch SUB TRIM value should be set to zero in transmitter.
Item
Content
－100 ~ +100
(Default 0)
Adjust the position of pitch at 0 collective pitch as well as the value until the
swashplate is in horizontal.
SENS DIRECT DEAD Submenu Configuration Steps:
1. AIGY-DIR----- Calibration Direction Selection for Aileron Sensor
Item
Content
NORM
（
(default)
Lift the helicopter, incline the body with left higher than right, the swashplate shall be
calibrated with left lower than right, if it is calibrated with left higher than right, please
adjust the data to
「
REV
」
REV
Lift the helicopter, incline the body with left higher than right, the swashplate shall be
calibrated with left lower than right, if it is calibrated with left higher than right, please
adjust the data to
「
NORM
」
Suggestions
First record the values of AIL-FEED, the values of AIL-FEED be set to zero, select the
calibration direction of the aileron sensor by following the above procedures properly, and
restore the values of AIL-FEED. If the helicopter turned on one side as take-off from the