7
32. Check the hinge gap and keep it small.
Using the shaft of the pin as a guide is a
good idea.
33. When satisfied with the fit of the aileron,
CA it in place with a quick shot of thin CA
glue. Flex the control surface down and
add 3 drops to each hinge then flex
aileron up and repeat the process.
34. Nip the excess screw length off with a pair
of side cutters or a Dremel cut-off wheel.
35. Locate the remaining 2 nylon control
horns and the longer screws and install in
the pre-drilled locations on each aileron.
