6
25. With servo mounted on hatch, extend the
length of the servo wire with a 12”
extension. Tape the connection so that it
cannot be pulled loose.
26. Tie the male plug end of the extension to
the pull string located in the wing.
27. Cut open the hole on the bottom of upper
wing near the cabane strut attachment.
28. Fish the servo extension through the wing
and out the exit hole.
29. Repeat this process for the other aileron.
30. Screw each hatch in place using 4 small
washer head screws.
31. Install the CA hinges in the leading edge
of the ailerons. Insert them 1/2 way in the
control surface and pin the center to
prevent the hinge being further inserted.
