Hobbies & Helis Octane Dominator 20, Instruction Manual

Page: 28 / 105

Page 28 of 105
Assemble and install Landing Gear
No. Bag# Description Qty
1 3 Landing Gear Strut 2
2 3 Landing Gear Skid 2
3 3 Landing Gear End Cap 4
4 3 M2.5x6 Self Taping 4
5 3 M3x14 Cap Head Bolt 4
6 3 M3 Locknut 4
7***** CA Glue 1
8***** 4 Optional skid feet
• Drill 4 holes in the Landing Gear Struts with a 3mm drill bit with a spacing of 92mm
• Install the Landing Gear Skids into the Struts.
• Apply CA Glue into the Landing Gear End Cap then insert them into the Skids.
• Drill four 2.4mm holes into the little rounds on the ends of the Struts then secure them
with the four M2.5x6 Phillips Screws.
You may at this time jump ahead if you like to the motor assembly and installation starting on page
48 through to the installation into the lower frame assembly.