Hobbies & Helis Octane Dominator 20, Instruction Manual

Page: 25 / 105

Page 25 of 105
Step 9
Install radio tray:
If not already done, you must prepare the radio tray for the flathead screws by
beveling the holes with a 45 degree countersink bit. If using a drill press, set it up with the bit
lowered to any hole and drill in small increments until you reach the proper depth then set
the depth stop on the drill press for the rest of the holes.
Use (8) 3mm x 6mm Phillips flat head screws to install the radio tray to the
crossmembers members and upper fuel tank assemblies. Tighten them and then finish
tightening the previously left loose crossmembers member screws. The radio tray and tank
should be flat and secure now.
Customer to countersink holes:
Yep Loctite!