Hobbies & Helis Octane Dominator 20, Instruction Manual

Page: 21 / 105

Page 21 of 105
2-2 FUEL TANK ASSEMBLY
No. Bag# Description
1
In box Tank Clunk
2 In box Medium Tygon Hose(gasoline line)
3 In box Long Tube
4 In box Tank Rubber Plug
5 In box Short Tube
6 In box Tank Fuel Plug Bottom Flange
7 In box Tank Fuel Plug Top Flange
8 In box M3x25 Cap Head Bolt
9 Fuel Tank
• There are three (2) lines (Aluminum fuel tubing) that need to be constructed for the tank
assembly. One line is the fuel pick-up line and requires a length of tubing for gasoline use running
from end of alum. The other line is venting line, which should be bent to reach the top of the tank on
the inside. You can use the same pick-up line for refueling line by inserting a T connector (Triangle
Joint) in the line. Tighten M3x25 Cap Head Bolt but do not tighten too much.
• Insert the whole construction into the Fuel Tank. Continue tightening M3x25 Cap Head
Bolt but do not over tighten or you will ruin rubber stopper!
• Do not use filter on fuel line to engine.