117
Maintenance
•
Open the quick-release.
•
Pull the rear wheel downwards out of
the frame
•
Remove the belt from the rear pulley
without twisting.
•
Push the transport lock between the
brake pads.
6.6.3. Changing the tyre/tube
•
Unscrew the valve cap and large knurled nut from the valve.
•
Completely release the air by applying pressure to the valve pin in the centre of
the valve.
•
Use tyre levers to loosen the tyre on one side of the rim.
•
If necessary, use detergent and water to lift the tyre off more easily.
•
Remove the tyre and tube and implement the desired change.
•
Lightly inflate the tube and insert it into the tyre.
•
Observe the running direction of the tyre imprinted by the manufacturer.
•
Then lever the other side of the tyre onto the rim using tyre levers.
•
Turn the knurled nut onto the valve until it reaches the rim.
•
Inflate the tyre to the maximum pressure indicated on the tyre wall so that the
tyre sits evenly on the rim. It is normal to hear a "plop" when doing so.
•
Then lower the pressure to the desired value (see section 3.1.).
•
Screw the valve cap onto the valve.
6.6.4.
Fitting the front wheel
•
Remove (when inserted) the yellow transport
lock from between the brake pads.
•
Carefully thread the front wheel into the fork.
Make sure that the brake disc slides between
the brake pads.
•
Push the thru-axle into the fork and hub.
•
Tighten the axle with the quick-release lever
and fold the tensioning lever down at the end.
The thru-axle is securely fixed when the tensioning lever leaves a force-
induced imprint on the palm of your hand when folding it down.
Summary of Contents for XD2 Urban Rohloff Pedelec
