16
ASSEMBLY INSTRUCTION:
NOTE:
1. Washer should be placed on both ends of all bolts (against the head of the Bolt and against the nut) unless otherwise
specified In these instructions.
2. Tighten all bolts by hand on initial assembly and finally tighten with the wrench once the entire structure is erect.
3. Some parts may be pre-assembled at the factory.
4. Assembly requires the assistance of another person.
STEP 1
1. Set the Foot End Cap(#55) to the end of parts(#33,#34,7#).
2. Insert the Guide Rod(#5) to the hole of part(#34), and then attach the part(#1,#7) to the part(#34) using (2) M10*80 Hex
Bolts(#84), (4)
φ10 Arc Washers(#75) and (2)M10 Nylon Lock Nuts(#68). Attach the Guide Rod(#5) to the part(#34) using
(2)M10*20 Hex Socket Bolts(#87). Wrench tighten these bolts here.
3. Attach the part(#33) to the part(#1) using the Back Plate(#10) and (2)M10*80 Hex Bolts(#84).
4. Attach the part(#3) to the part(#1) using (2)M10*80 Hex Bolts(#84), (4)
φ10 Flat Washers(#72) and (2)M10 Nylon Lock
Nuts(#68).
5. Attach the part(#18) to the part(#1) using (1)M12 Nylon Lock Nut(#69). Wrench the nut until it is flush with the screw shaft.