four M8x16 Bolts (42
), Φ8 Spring washer (50) and Arc washers (34). (Refer figure 3)
5) Attach the Handle Pulse Tube and Computer
a.
Insert the Tension control wires (19) through into the hole of the Handlebar
support (7) and then pull them out from the top hole of Handlebar support (7). Attach
the Handlebar (8) to the Handlebar locator(A) of the Handlebar post(7) with the
Handlebar cover(69), then insert the Tension control wires(19) into the hole of the
Handlebar support(7) with the Pole plug(70), and put the Spacer(70) on the
T-knob(71). Adjust the handlebar to the proper position, and lock with the T-knob(71)
tightly.
b.
Connect the Computer wire (18) and the Pulse wires (19)and sensor wire, insert
the surplus wire into the Handlebar (7).then insert the Computer (11) to the top of Handlebar support (7) ,make sure the computer
is inserted to the handlebar support firmly. then tighten it with M5*10 cross-head screw(74) (Refer figure 4)
6) Attach the Seat Adjustor
First, remove three M8 Nylon Nuts (59) and
Φ8 Flat washers (55) from underneath of
the Seat cushion (20), and then attach the Seat cushion (20) to the Seat cushion
adjustable bracket(62) with the three M8 Nylon Nuts (59) and
Φ8 Flat washers (55)
that were removed. (Refer figure 5)
Take out D-shaped washer( below 26 mentioned parts ) from the hardware package,
and with the groove of the D-shaped washer (26) aiming to the slot of the seat support
of the main frame (4), pat the D-shaped washer (26) gently into the main frame (4) ,
and then insert the Seat bracket (16) to the D-shaped washer (26) and the seat
support of the main frame (4); insert the insert the Seat adjustor (16) into the hole (Refer figure 6). Finally, attach the Seat cushion
adjustable bracket (62) to the top of Seat Adjustor (16) with short knob (64), adjust the saddle support plate to the appropriate
position, and then tighten the short knob (64). (Refer figure 7)
