ASSEMBLY INSTRUCTION
1
）
Attach the Front Stabilizer
Attach the Front stabilizer (5) to the Main frame (4) with two M8*20 bolt (49
), Φ8
Flat washer(55
) andΦ8 spring washer(50).(Refer figure 1)
3) Attach the Rear Stabilizer
Attach the Rear stabilizer (1) to the Main frame (4) with 2 sets of M8*20 bolt(49), Φ8
Spring washer (50) and Φ8 flat washer (55). (Refer figure 2)
4) Attach the Handlebar Support
a.
Put the cable end of resistance cable of Tension control (41)into the spring hook of Tension control wire (38) as shown on
drawing
A
of figure 3.
b.
Pull the resistance cable of Tension control (41) up and force it into the gap of metal bracket of Tension control wire (38) as
shown on drawing
B
of figure 3.
c.
Connect the resistance cable of Tension control (41) with the Tension control wire (38) completed as shown on drawing
C
of
figure 3.
d.
Insert the Computer wire (17&18) through into the bottom of Handlebar support (7) and pull it out from the top hole of
Handlebar support (7).
e.
Insert the Handlebar support (7) to the Main frame (4) and secure it with
