HMS BE5000-i, Manual Instruction

Page: 33 / 56

33
BE5000-i
Warning:
1) The safety level of the equipment can be maintained only if it is examined regularly for damage and wear, e.g. pins,
connection points.
2) Please replace defective components immediately and/or keep the equipment out of use until repair.
Malfunction Reason Treatment
Power on but no display on the
computer
1. Plug incorrectly.
2. Overload protection switch is off
3. Transformer is inserted incorrectly.
4. The fuse in the driver is burned. 1. Plug it again.
2. Reset it.
3. check it up or replace it.
4. Replace it
Show Er01, Speed sensor
malfunction
1. Speed sensor is broken or installed
incorrectly.
2. Optocoupler in the driver is damaged
3. Other parts outside IC is broken.
1. Check up the install position or replace
the speed sensor.
2. Replace Driver or the Optocoupler.
3. Replace driver.
Show Er02, motor electricity
overload malfunction
1. Overload current through the motor.
2. Obstruction of the roller is too much.
3. Driver is damaged. 1. Replace the motor.
2. Enhance lubricating or replace it.
3. Replace the driver.
Show Er03, Correspond failure
1. Undesirable signal wire.
2. Optocoupler in the driver is damaged.
3. Computer is damaged.
1. Check up the signal wire’s connector to
the computer and the driver.
2. Replace driver or the Optocoupler.
3. Replace computer board.
Show Er04, driver power
malfunction
1. Motor haven’t inserted well or motor’s
damaged (broken circuit).
2. The relay of the driver is damaged.
3. The bridge of the driver is damaged.
4. Other parts outside IC is damaged.
1. Check up or replace a motor.
2. Replace driver or relay.
3. Replace driver or bridge.
4. Replace driver.
If incline window will show “--”,
incline is in malfunction.
1. Incline motor sensor insert incorrectly.
2. Incline motor sensor is damaged.
3. Parts in the driver is damaged. 1. Check up the connection of the plug.
2. Replace incline motor.
3. Replace driver.
Without loading, operate
normally. With loading, hard to
start and with stops. 1. Driver’s torque regulation is small.
2. Running belt gets loose.
3. Undesirable motor. 1. Adjust the torque.
2. Adjust running belt.
3. Replace motor.