HMS BE3200, Manual Instruction

Page: 29 / 66

■ 4.1.5 body mass index reference table
●
Fat percentage reference table
●
Adult body mass index(BMI) reference table
◆
5 Hand pulse test
5.1
●
After and before exercise, it can monitor exerciser’s pulse of static, dynamic and recovery status. Exerciser hold
the left and right hand touch pulse monitored metal, pulse value will be shown on the screen. (Warm tip: the max
pulse value do not over (220-age) when exercise. If over the max pulse, it’s suggested to rest for 30 minutes, or
reduce speed and incline. The test result is just for your exercise reference).
Maintenance and malfunction treatment
1. Clean
：
The surface of the treadmill should be
kept clean, pull out the power wire before cleaning.
You can clean the running belt and the surface of
the treadmill with a soft and wet cloth.Do not use
strong solvents
2. Adjust belt deviation: The running belt has
been well adjusted at factory; it may run defectively
after transportation and improper use. Turn off the
treadmill before adjusting (as the right figure
shown), adjust the left and right bolts in rear roller with hex wrench.
If the belt is deviation to left, clockwise rotate the left bolt. If the belt
is deviation to right, counterclockwise rotate the right bolt. It is better
to adjust 1/2 circle each time. Then turn on the switch, check if the
belt
runs defectively when the running speed is 4~5 km/h. Repeat to adjust to the belt to the center (see as figure).
3. Adjust belt slip: After using for some time, the belt may be extended and stuck. Your should adjust the left and
right bolts in rear roller clockwise at same position till the runs smoothly, it is better to adjust 1/2 circle each time. But it
should not be adjusted too tight, so as to avoid shortening the service cycle.
4. Lubricate: After using over 100 hours or the lubricant between the running board and the running belt is used
up, you should lubricate the running board.
12