HMS Anybus HMS-EN2MB-R, User Manual, Page: 12 / 72

Installation 10 (70)
3.2.1 DIN-rail Mounting
Make sure the DIN-rail fastening mechanism on the back
of the module is in a fixed and closed position, i. e. pushed
all the way up.
To mount the module, first hook it on to the DIN-rail (1),
then push it against the DIN-rail to make it snap on (2).
To unmount the module, a screwdriver is needed. Use the
screwdriver to push the DIN-rail fastening mechanism on
the back of the module down until it locks in a fixed and
open position (1). Then unhook the module from the DIN-
rail (2).
Do not leave the module with the DIN-rail fastening
mechanism in a fixed and open position. This may
eventually wear the fastening mechanism out so it cannot
be used efficiently. Be sure to push the DIN-rail fastening
mechanism back into the fixed and closed position after
demounting the module.
3.2.2 Wall Mounting
Use the wall mounting option if there is a need to place the linking device in an environment
exposed to vibration. This way of mounting the module offers more stability than the traditional
DIN-rail mounting.
: The device should be fastened in a standing-up position, to ensure a constant air flow.
When mounting the device to a wall using the wall mount option, do not forget to connect the module to
protective earth (PE) via the power connector.
Linking Device User Manual
scm-1202–181 2.0 en-US