INSTALLATION INSTRUCTIONS
TRU-FIT
DOOR & PANEL
FIGURE 20A
STEP 20
With door in the open position, carefully remove the Glass Panel (P) and
Glass Blocks (Q) and drill pilot holes in curb channel as shown in Figure 20
A. Replace the Curb Channel (D) under the Wall Channel (C). Use a pencil
to mark for pilot holes and remove channel for drilling. Using a 3/16” drill bit,
drill two pilot holes through the Curb Channel (D) into base (See Figure 20A).
Space both holes per Figure 20A.
PUT A DROP OF SILICONE
in holes, re-
place Curb Channel (D) and secure with #8 x 2” Screws (K). (See Figure 20B)
FIGURE 20B
FIGURE 21A
FIGURE 21B
STEP 21
Place two stacks of three Glass Blocks (Q) inside the Curb Channel (D) per
Figure 20A.
NOTE: DO NOT SET ON SCREW HEADS.
These glass
blocks will be used not only to cushion and protect panel from screw heads
but to also adjust the height of the panel to match the door. You can remove
glass blocks to lower panel, cut glass blocks in half and stack more than three
to raise the panel. (See Figure 21A). When ready to install glass, put four or
five globs of silicone on the inside of the wall channel (See figure 21B). Set
Glass Panel (P) in the Curb Channel (D) on Glass Blocks (Q) and gently push
into Wall Channel (C) until glass is event Curb Channel (D).
FIGURE 22
STEP 22
Double-check that the height of the Glass Panel (P) is even with the Glass
Door (O) and 1/8” gap between pieces of glass is uniform. (See Figure 22)
V5_21_26