
INSTALLATION INSTRUCTIONS
STEP 29
There are three different polycarbonates provided. All are
OPTIONAL and serve to help prevent water from escaping
shower.
NOTE: If using the optional polycarbonates, for the best adhesion,
clean glass or tile with alcohol before application.
ZV 952 Bottom Sweep (L)
- This is attached by pressing it on
bottom of door while door is open. Wood block should have
been removed. (See Figure 29A)
ZV SDTB Bulb Seal (N)
- This is to be placed on hinge edges
of glass. You will need to cut into 3 pieces that will fit the small
areas from top hinge to top of door, bottom hinge to bottom
of door and the large area between hinges. Remove red cover-
ing to expose adhesive and apply to edge of glass.
(See Figure 29B)
ZV Angle Seal (M)
- This is to be placed on handle side of
door, DIRECTLY to the Panel Glass (P) (make sure glass is
clean and dry before application). (See Figure 29C)
CAUTION: By using this angle seal, your door will no
longer be able to swing both in and out.
(See Figure 29C)
TRU-FIT
DOOR & PANEL
FIGURE 29A
FIGURE 29B
FIGURE 29C
IMPORTANT
NOTE
DOOR SHOULD NOT BE USED FOR 72 HOURS
IN ORDER TO LET SILICONE CURE PROPERLY!
V5_21_26